Hi @soft.beach7708 ,
Aha! Then I’d use two Set Variables and One Get Variable to amalgamate the results of those that your were happy with and those that had to be run again:
Can you see from this screenshot (it is a bit small) that:
Route 1 has a filter so that it runs the AI again, and then sets a new Variable.
Route 2 has a filter to only sets the new Variable if there was no problem with the output.
Route 3 then uses “Get variable” to pick up the new variable (the result of Routes 1 and 2), and then combine these in a Text Aggregator. Route 3 doesn’t have a filter, so will always run. But Route 3 must run last.
The order that Routes run depends on the order you link them to the Router. So to re-order routes, Unlink them and re-link.