ROuter do not get message from JSON Parse

Beginner Questions
,
1

:bullseye: What is your goal?

I want text to go from my OPENAI module to a Parse JSON, then a router with 3 routes and then 1 route to a Airtable module

:thinking: What is the problem?

I want text to go from my OPENAI module to a Parse JSON and then to a Router but all connections run up fine to the Parse JSON then nothing

:test_tube: What have you tried so far?

I have deleted and added all modules updated the prompt in the Open AI module and all boxes check green except the router

:camera_with_flash: Screenshots: scenario setup, module configuration, errors

Route NEW.jpg
Route NEW.jpg1710×922 80.9 KB

3

Hey there,

you don’t need a parse JSON after the openAI module, go to advanced settings and tell it to give you a parsed JSON directly.

Also, in your screenshot, there is nothing after the parse JSON to run.

2 Likes
4

Welcome to the Make community!

:up_arrow:

Filters are attached to the module immediately after them.
What you see in your screenshot are just gray placeholders for you to insert a module in its place.

As there are no modules after the filter, those filters are in “draft mode” until you attach a module to them.

If you have a follow-up question, please start a new thread. Thanks!

— @samliew
P.S.: investing some effort into the tutorials in the Make Academy will save you lots of time and frustration using Make!