Scenario stuck - Unable to initialize after deleting incomplete executions

How To
1

I have a few scenarios that require sequential processing in all of them. I had set them to save incomplete executions. (To be honest they dont require sequential processing, they require one by one processing, the order is not importante, but sequential processing seems to be the way to go).

A problem on the scenario lead to incomplete executions stopping it temporarily.
Make shows a warning: “The scenario has been temporarily paused. The reason for stopping the scenario is that it is set to process data sequentially and the queue of incomplete executions is not empty.”

I fixed the scenarios, and I deleted the incomplete executions because they were not important. Now, nothing i do can initialize the scenario again so that my webhook queue continues running. Even though the incomplete executions tab is empty i still get the message:

“The scenario has been temporarily paused. The reason for stopping the scenario is that it is set to process data sequentially and the queue of incomplete executions is not empty.”

3

Hello @Rafael_Bepex :waving_hand: and welcome to the Make community!

Thank you for your patience.

I’m happy to let you know that the issue has been resolved by our development team. Everything should be working as expected now, but please don’t hesitate to reach out if you encounter any further problems. :hugs:

3 Likes
4

Hi Misha, thanks a lot for your prompt reply. However I dont know if the issue will be fixed for people who happen to delete incomplete excecutions in the future… but my scenarios are still paused with the same status as before: as if there were incomplete executions, when there are none.

I can clone them, but i will lose my queue, which is a shame.

5

Hello,

Thank you for getting back to me. Kindly make sure to activate the scenarios where you were facing the issue. :slight_smile:

6

Hi Misha, thanks a lot for your attention to this matter again.

I have already deactivated and reactivated them a few times. I have also tried turning sequential processing off and on again a few times, and even letting it excute out of sequence and turning sequential on again. Nothing works.

7

Hello @Rafael_Bepex :waving_hand:

I’m very sorry to hear that. As I can see, colleague from our CC team is in touch with you and it’s the best way to get assist on this. I believe it will be solved soon. :folded_hands:

Thank you so much for your patience.

1 Like