Error Handling with specific focus on using Break to retry automatically

[Solomon_Eko]

What are you trying to achieve?

Using the Break directive to retry automatically

Steps taken so far

I have deleted the scenario and started over many times but I keep getting the same error.

Screenshots: scenario setup, module configuration, errors

blueprint (1).json (11.7 KB)

[samliew]

@Solomon_Eko

I keep getting the same error.

What is the error?

Handle errors so scenarios don’t stop.

You might want to add some error handling to your modules to handle exceptions, so the failing module(s) can automatically be retried or ignored. By handling any errors by adding a “Error handler” to the module, the scenario won’t throw an error and get turned off.

Error directives can only be added to an error handler route.

1. Right click and select “Add error handler”

2. Error handlers will appear

For more information on error handling, see:

• Introduction to errors and warnings in Make
• Overview of error handling in Make
• Error handlers
• Overview of error handling in Make
• Watch these videos by Make - Learn all about error handling (YouTube playlist)
• Webhook Error Handling
• Types of Errors (including RateLimitError HTTP 429: too many requests)

Hope this helps! Let me know if there are any further questions or issues.

— @samliew

P.S.: Investing some effort into the Make Academy will save you lots of time and frustration using Make.

[Solomon_Eko]

Thank you for the feedback.