I’m having tones of difficult with these http modules in my scenarios. My code is properly formatted in the request content. I don’t know what to do anymore, I need someone to see what I don’t see. Please look over my screenshots and help me to understand what I’m doing wrong.
Welcome to the Make community!
If the format is correct, which it looks like it does, then the only thing left you can do is to get a new API key from the external service.
The error message says your API key is incorrect.
Hope this helps! Let me know if there are any further questions or issues.
— @samliew
P.S.: Did you know, the concepts of about 70% of questions asked on this forum are already covered in the Make Academy. Investing some effort into it will save you lots of time and frustration using Make later!
Please please please make sure to create a new API key or remove the screenshots exposing your API keys from the topic. ALWAYS hide your API keys, you cannot imagine the disastrous consequences of exposing API keys.
Cheers,
Henk
1 Like
Silly mistake, thanks for the heads up.
1 Like
Hey need your help again. I took your advice and grabbed a new API key from any mail finder and put it in beside Bearer in the http module on make.com and ended working when I run module only for http. However I’m building out the exact same scenario and the same error is popping up again. Error 400 bad request. Do you see anything wrong in the screenshots?
I think when the module ran, the variables
1.companyName
2.choices[].message.content
is empty. The error message says it can’t be empty.
Try running the full scenario so it won’t be empty.
Hope this helps! Let me know if there are any further questions or issues.
— @samliew
P.S.: Did you know, the concepts of about 70% of questions asked on this forum are already covered in the Make Academy. Investing some effort into it will save you lots of time and frustration using Make later!