Queue is full - Scenario switches off

[L_Duperval]

It’s possible. It seems like someone else ran into this last year:

Problem in a scenario (Update contact)

Hi @Barwodder, Welcome to the Make community! You don’t have to “check” whether the contact exists first - that’s an extra unnecessary step. 1. All you need to do is add an error handler to your “Create a Contact” module [Screenshot_2023-10-16_211056] 2. Then, add an “Update a Contact” module. [Screenshot_2023-10-16_211038] Optional Both modules return a Contact ID, which you can use in a Resume directive module, if needed, to continue the scenario as if the “Create a Contact” module su…

Can you share a snapshot of your scenario, especially the sections that are doing error handling?

This discussion might be helpful for you also, even though it isn’t specific to Breco:

If/Else route when contact does not exist (error handling)

I have a module “Get a Contact” (Sendinblue). If the contact isn’t found, I “Create a Contact”. If the contact is found, I “Update a Contact”. Screenshot below, I thought this was a simple way to do that, but it understandably sends me warning emails “Contact does not exist” whenever the contact isn’t found. [Screen Shot 2022-12-21 at 12.12.28 PM] I need the scenario to finish regardless of whether a contact is found, so what’s the right way to do it? Thank you!

L